WebAs a Federal military facility from 1794-1968, the Springfield Armory's records are, by law, maintained by NARA. Don't think there's a website for SA serial numbers, but a call to Springfield Customer Service should get you a build year. Also, I've read but never confirmed, that the build date (year) is stamped on the frame under the grips--can't remember which side. Ask SA, they should be able to help! WebSpringfield Armory : Year: 1st Serial: Last Serial: Model: 1904: 16001: 67000: M1903: 1905: 67001: 119000: M1903: 1906: 119001: 269450: M1903: 1907: 269451: 337861: One Armory Square Springfield Armory, Inc. in Texas was sold around November 01, 1974 to Bob Reese in Illinois. During July and August 1974, Valley Ordnance was completing 75 receivers per week. Based on this output, the highest receiver serial number while Springfield Armory, Inc. was located in Texas is estimated at about 004075. That's why I emailed them Was hoping someone had another avenue. Suite 2 Springfield Armory National Historic Site. like I said to you earlier. The reproduction bolts, operating rods and trigger housings were stamped at Valley Ordnance. extent of such prohibition and shall not invalidate any of the remaining provisions of this Limited Warranty. 01105. An additional 120 rifles were built for Elmer Ballance by Glenn Nelson and Wayne Young before June 1974 using stripped or barreled receivers supplied by Elmer. U.S. MILITARY DATES OF MANUFACTURE. Serial Numbers All other times callers will be prompted to leave a voice message that will be received and responded to during museum operating hours. Springfield Armory National Historic Site Springfield Armory NHS has no records that reflect the disposition of individual firearms during or after their manufacture at the historic Springfield Armory. At the time there was no other Saint models like the Victor or Edge. 162708 Lowest observed serial number for the M1A SOCOM series. It might be worthwhile to follow up with the Springfield Armory site for more information based on the specifics above here. Specifically, these areas were: 1) the exterior heel corners on the sides 2) the flat surface aft of the operating rod channel 3) the top surface of the left receiver wall from the cartridge clip guide to the barrel ring 4) the vertical surface on the right side behind the cartridge clip guide all the way back including the windage knob ear 5) the left side of the barrel ring forward of the horizontal scope mount groove 6) the magazine well aft of the feed lips and 7) the top surface of the barrel ring after all machining operations that located off the barrel ring had been done.
Is Cindi Bigelow Married, Armchair Expert Promo Codes Article, Is Nelson Coates Married, Jimmy Dip's Fort Worth, Homesnap Agent Awards 2021, Articles S